Calculation command

Commands enable the automatic summing up of numerical values entered by the user ("Number" command) and verifies the result with specified spreads (minimum vs. maximum), if the results are not included in the spread the user cannot finish the task (they must interrupt the task or correct the values in the number to corresponding spreads commands). The "Calculation" command is a technical command not included in the results of the completed task.

Command configuration parameters:

  • Command title (up to 80 characters).
  • Command description (up to 600 characters).
  • Minimum acceptable value - Value not less than 0, which must be reached from the sum of the value to be able to continue.
  • Maximum acceptable value - Maximum value that must not be exceeded in order to continue.
  • Command ID to be summed - Command ID number to be summed and compared within the boundaries (minimum vs. maximum).
  • Content of the message for error - Content of the message for the user if the sum of the values entered in the commands number of values does not fit into the boundaries (minimum vs. maximum).
  • Order in reports.

Command view in application

Command view when the sum of values from the commands is correct:

Command view when the sum of values from the commands is incorrect:

Article rating / Czy to odpowiedziało na Twoje pytanie? Article rating success / Dziękujemy za wiadomość There was a problem submitting your feedback. Please try again later.

Still Need Help? / Dalej potrzebna pomoc? Contact Us / Kontakt z nami Contact Us / Kontakt z nami